Cisco 8600 Series Manual page 20

Powering on the router

Hide thumbs Also See for 8600 Series:

Power Up a DC Power Supply Unit

Figure 28: Close Terminal Block Cover

Power Up a DC Power Supply Unit

After you have installed the Power Supply Unit (PSU) in the chassis and connected the DC-input wires, follow

the steps described here to power up the module and verify that the module is installed correctly.

Before you begin

Warning

Procedure

Step 1

For the powered down circuits connected to the PSUs, turn on the power at the circuit breaker.

The FAIL LED is illuminated for two to three seconds after DC input is applied through a circuit breaker.

Step 2

Check that the INPUT and OUTPUT LEDs on the PSU are green.

Note

Powering on the Router

Statement 1030 Equipment Installation

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Statement 1073 No User-Serviceable Parts

There are no serviceable parts inside. To avoid risk of electric shock, do not open.

DC-input PSUs are shipped with the power button in the default auto-on mode, which means that

the unit automatically starts on application of DC-input power. When you install a new or

replacement unit straight out of the box, you do not have to press the power button.

Powering on the Router