GE A3-5825B Use And Care Manual page 6

EAS D SONNECTING TYPE
MOU TING BRACKET
SPRING WASHERS
TAPPING SCREWS
MACHINE SCI
MICROPHONE HOLDER
I
ZED DC POWER PLUG
WITH IN-LINE FUSE
(3 AMP)
HO
L
VOLTS DC
3.5 MM PLU
TO PA SP
QUICK RELEASE
CUT OUT
MIC HOLDER
MOUNTING HOLES
TOP OF DA
l
OOR MOUNT UNDE
MOUN
TRUCK CAB
Install unit as shown in REAR PANEL sketch. Tools required: A) #30 drill (1/8 inch.)
B) Phillips head screwdriver
1. Mount CB so all controls are conveniently available to you (the operator) without interfering
with movements for safe driving of your vehicle.
2. Be sure all cables are clear of brake, clutch and accelerator.
3.
Use MOUNTING BRACKET as template for drilling 1/8-inch holes. Mount bracket with
self-TAPPING SCREWS.
4. Install MICROPHONE HOLDER on either side of CB and mount it in horizontal or vertical
position to suit your own preference.
5. Use THUMB SCREWS to secure the CB to MOUNTING BRACKET.
NOTE: Do not mount transceiver in heater or air conditioning air flow path.
6. Connect antenna plug to antenna jack on rear of unit (see ANTENNA section for further
information).
7. Connect DC power plug to DC 12V jack located on rear of unit (see POWER CONNECTION
section for further information).
6