Table of Contents
Advertisement
Fluidmesh 1200 VOLO
Figure 8. Device connector ports
Connect the included 24 Vdc PoE injector to the unit by doing the
following steps:
1.
Only use a patch Ethernet cable to connect the PoE injector and
the unit.
2.
Insert the RJ45 connector leading from the PoE injector into the
Ethernet port labelled LAN1/POE.
5.1.5. Rebooting the firmware and resetting the unit to factory
defaults
The Fluidmesh 1200 VOLO hardware can be rebooted and reset to
factory default condition using the procedures in this section.
© 2020 Cisco and/or its affiliates. All rights reserved.
CAUTION
The unit is designed to take power through 24 Vdc Power-
over-Ethernet only, and does not have a dedicated power port.
A 24 Vdc PoE injector is included with the unit. Do not connect
any 48 Vdc PoE injector, and do not attempt to connect any
other source of electrical power to the unit.
IMPORTANT
The following procedure shows how to do a 'hard' (device
firmware) reboot. To do a 'soft' (device software) reboot, refer
to
"Resetting the unit to factory defaults" (page
131).
Page 32 of 169
Advertisement
Table of Contents
