Receiving; Receiving A Call With Your Station Code; Receiving A Call With A Group Code - Kenwood TH-22A Instruction Manual

RECEIVING
1 Tune to the prearranged frequency.
2 Press [F], [1] to switch ON Page.
@ "PAG" appears.
You are ready to receive a call addressed with your
station code or a group code. If no signal is received for
more than 2 seconds after a Page has opened the
squelch, the squelch then closes.
mg Receiving a Call with your Station Code
When a signal is received encoded with your individual
code, the squelch opens and you hear an alert tone
from the speaker. In addition, the display shows "OP"
and the calling station's code.
Press [PTT] while "PAG" is blinking to respond to the
calling party.
m Receiving a Call with a Group Code
When a signal is received encoded with the correct
group code, the squelch opens and you hear an alert
tone from the speaker. In addition, the display shows
the received group code and in which memory (1 to 6)
that group code has been stored.
Press [PTT] while "PAG" is blinking to respond to the
calling party.
Note:
» The microphone is inhibited while the Page code is
transmitted.
» it's advisable to turn OFF Battery Saver when you use
Page.
45