Leds; Solution - AEG 11191 Original Instruction Manual

24 www.aeg-automotive.com

LEDS

LED LED
„Power" „Charge"
green green
= on = off

SOLUTION

DaNGER!
Risk of electric shock and fire!
Always stop the charging process before discon-
necting the charging coupler from the vehicle.
1. Disconnect the charging coupler (9) from the
vehicle's charging socket.
2. Unplug the mains plug (1) from the 230 V mains
socket.
3. Wait at least 10 seconds.
LED LED
„Fault 1" „Fault 2"
red red
= flashing
Description
No or faulty connection.
Device ready.
Charging.
Charging completed.
No earthing via earth wire detected.
Self-test failed.
The verification process for the self-test will start automati-
cally.
Communication error.
Over- or undervoltage.
Excess current.
Slow charging due to leakage current.
Mains plug temperature too high.
Allow the device to cool down.
Control board temperature too high.
Allow the device to cool down.
4. Plug the mains plug (1) into a 230 V mains
socket.
5. Connect the charging coupler (9) to the charging
socket on the vehicle.
If you encounter the error again, immediately have
the device inspected by a specialist shop.
Never operate the device if it is not working prop-
erly.