Table of Contents
Advertisement
CHAPTER 10: MAINTAINING A D20E MODULE FIRMWARE
Reset device communication protocol and point
mapping
D20E ETHERNET I/O MODULE INSTRUCTION MANUAL
In the event that it is necessary to reset the communication protocol and point mapping on
a D20E device to the factory settings, you need to load the D20E device template.
If a D20E device is connected to:
•
A GE Grid Solutions D2x (for example, D20ME, iBOX, D25), D20MX, D400, or DMC490
device, only use the device template files provided on the D20E Doc CD.
If you restore the D20E to the template files available on DAPserver Studio, the
communications protocol settings will not be correct for connection to D20, D20MX,
D400, or DMC490 devices.
•
For any other device, restore the factory settings from the device templates provided
on DAPserver Studio.
GE INFORMATION
113
Advertisement
Table of Contents
