Display Setup-Cea Assign - Honeywell S7800A1142 Manual

Fig. 48. CEA Edit/Edit Msg screen.
Use the up/down and left/right arrows to select Msg (message)
number you wish to edit. Press ENTER using the two ENTER
buttons at the same time to select.
Fig. 49. Select/Exit screen.
Choose Select.
Fig. 50. CEA Edit Msg XX/Default XX screen.
Using the left/right arrow will move the cursor left and right. Up
and down arrows will move you through the series of available
script (see Table 9). Up to 12 characters can be used in your
message.
NOTE: Moving through the characters script:
1. Pressing and holding an up/down arrow will fast
forward to the end of the current script.
2. A space is located between the capital and lower
case alphabet.
3. A space is added if you move the cursor right
when it is under an empty character position.
< Clear
Fig. 51. Save/Exit/Clear EOL screen.
Pressing the left arrow will clear text on the second line and
return you to CEA Edit screen.
When you have finished entering your description, press the
ENTER keys.
< Clear
Fig. 52. Save/Exit/Clear EOL screen.
Press the Down arrow to Save. Suggest that you record the
message number with your custom description.
7800 SERIES S7800A1142 KEYBOARD DISPLAY MODULE
Repeat the above steps for the remainder of the custom
descriptions you wish to create.
When you have completed your final message, press ENTER.
Fig. 53. Save/Exit/Clear EOL screen.
Use up arrow to select Exit.
Fig. 54. DISPLAY Setup/Select CEA EDIT screen.
Press ENTER, then Exit if you are done or go to EA Assign to
assigning your custom message to a specific Expanded
Annunciator terminal.
Display Setup—CEA Assign
CEA Assign allows assigning a message to a given Expanded
Annunciator terminal. When it shows up on the display, the
description will match the specific system interlocks connected
to that Expanded Annunciator terminal. See Table 8 for current
message text list (messages 4 through 22), messages 23
through 44 contain other commonly used messages that could
be chosen or assigned. Messages 45 through 64 are editable
text strings edited through CEA Edit.
For example, the Expanded Annunciator terminal 7 is typically
Aux Limit 1, so on a shutdown for this open limit, the display
would show "Aux Limit 1." CEA ASSIGN will allow you to
change it to item 32 off the commonly used list, for example.
When done, the Aux Limit 1 would display "Recirc Fan".
S7800 does not support expanded annunciator if operating in
ModBus mode.
To access the CEA ASSIGN menu:
Press the left three buttons of the KDM for one second, then
release.
DISPLAY Setup will appear.
NOTE: If you have a personal password, enter it now to enter
SETUP.
Fig. 55. DISPLAY Setup/PASSWORD screen.
Press ENTER by pressing the two ENTER buttons at the same
time.
29
< Clear
65-0288-1