Honeywell S7800A1142 Manual page 30

7800 SERIES S7800A1142 KEYBOARD DISPLAY MODULE
Fig. 56. Select/Exit screen.
Choose Select.
Fig. 57. DISPLAY Setup/Select CLONE screen.
Use the down arrow to scroll through the menu choices until
EAASSIGN appears.
Fig. 58. DISPLAY Setup/Select CEA ASSIGN screen.
Press ENTER using the two ENTER buttons at the same time.
Fig. 59. Select/Exit screen.
Choose Select.
Fig. 60. CEA Assign screen.
Use the up/down and left/right arrows to select terminal
number (7 for above example).
Press ENTER using the two ENTER buttons at the same time
to select.
Fig. 61. Select/Exit screen.
Choose Select.
65-0288-1
Fig. 62. Assign screen.
Use the left/right arrow to move the cursor left and right. Use
the up/down arrows to change the message numbers (See
Table 8 for pre-set messages or use your custom description
from CEA EDIT. 32 is used from the above example.
The display will look like this:
Fig. 63. Assign T07 to msg 32 screen.
Press the ENTER keys to accept.
Fig. 64. Save Changes/Exit no Save screen.
Press the Down arrow to save.
Fig. 65. CEA Assign/Assign screen.
Suggest that you record the terminal number and message
with your custom description. Repeat the above steps to map
the Expanded Annunciator terminals to your specific system.
When complete with your final message, press ENTER.
Fig. 66. Save/Exit screen.
Use the up arrow to select Exit.
Fig. 67. DISPLAY Setup/Select EAASSIGN screen.
Press ENTER then choose Exit.
30