Turning Off The Appliance - Honeywell SmartValve SV9401 Installation Instructions Manual

Hide thumbs

Table of Contents

SV9401/SV9402/SV9403, SV9501/SV9502/SV9503, SV9601/SV9602 SMARTVALVE™

INSTRUCTIONS TO THE

HOMEOWNER

WARNING

Fire or Explosion Hazard.

Can cause property damage, severe injury, or

death.

Follow these warnings exactly:

Do not light the pilot flame manually.

Before lighting the pilot burner flame, smell

around the appliance for gas. Be sure to smell

next to the floor because LP gas is heavier

than air.

WARNING

Fire or Explosion Hazard.

Can cause property damage, severe injury, or

death.

If you smell gas:

• Turn off the gas supply at the appliance service

valve. On LP gas systems, turn off the gas

supply at the gas tank.

• Do not light any appliances in the house.

• Do not touch electrical switches or use the

phone.

• Leave the building and use a neighbor's phone

to call your gas supplier.

• If you cannot reach your gas supplier, call the

fire department.

The ignition system control must be replaced in event of

any physical damage, tampering, bent terminals, missing

or broken parts, stripped threads, or evidence of exposure

to heat, water, or excessive moisture.

IMPORTANT

Follow the operating instructions provided by the

manufacturer of your heating appliance. These

instructions describe a typical ignition system

control application, but the specific controls used

and the procedures outlined by the manufacturer

of your appliance can differ, requiring special

instructions.

STOP: Read the Warnings Above.

The pilot flame is lit automatically. If the appliance does not

turn on when the thermostat is set several degrees above

room temperature, follow these instructions:

1. Set the thermostat to its lowest setting to reset the

safety control.

2. Disconnect all electric power to the appliance.

3. Remove the ignition system control access panel.

4. Move the ignition system control switch to the OFF

position.

5. Wait five minutes to clear out any unburned gas. If

you then smell gas, STOP! Follow the Warnings

above. If you do not smell gas, continue with the

next step.

6. Move the ignition system control switch to the ON

position.

7. Replace the ignition system control access panel.

8. Reconnect all electric power to the appliance.

9. Set the thermostat to the desired setting.

10. If the appliance does not turn on, move the ignition

system control switch to the OFF position and

contact a qualified service technician for assistance.