Target Surfaces; Hazards Of Use - Makita LD060P Instruction Manual

Display
See drawing {B}
1 Laser "ON"
2 Reference (front/rear/end piece)
3 Pythagoras
4 Timer (self-triggering)
5 Historical memory
6 Area/volume
7 Battery status
8 Units with exponents (2/3)
9 Intermediate line 2
10 Intermediate line 1
11 A/lain line
12 min / max display
13 Info symbol
Start up
Inserting / Replacing Batteries
1 Remove battery compartment lid.
See drawing {C}.
2 Insert batteries, observing correct polarity.
3 Close the battery compartment.
• Replace the batteries when the symbol ||j flashes
permanently in the display.
cJP Only use alkaline batteries.
If the instrument will not be used for a long
time, remove the batteries as a protection against
corrosion.
Makita LD060P
Operation GB
Measuring Conditions
Range
Range is limited to 60 m.
At night or dusk and if the target is in shadow the
measuring range without target plate is increased.
Use a target plate to increase the measurement
range during daylight, or if the target has poor reflec¬
tion properties!
Target Surfaces
A
CAUTION:
Measuring errors can occur when measuring
toward colourless liquids (e.g. water) or dust free
glass, Styrofoam or similar semi-permeable surfaces.
Aiming at high gloss surfaces may deflect the laser-
beam and lead to measurement errors.
Hazards of Use
A
CAUTION:
Watch out for erroneous distance measure¬
ments if the instrument is defective or if it has been
dropped or has been misused or modified.
Precautions:
Carry out periodic test measurements.
Particularly after the instrument has been subject to
Start up