Changing The Presser Foot; Attaching The Edge/Quilting Guide - Husqvarna VIKING Onyx 15 User Manual

CHANGING THE PRESSER FOOT

1. Make sure the needle is in the highest position. Pull the
presser foot towards you.
2. Line up the cross pin on the foot with the gap in the pre-
sser foot ankle. Press back until the foot snaps into place.
Note: If you find it difficult to place the presser foot in the correct
position, keep the release button pressed while lowering the presser
foot. Use your thumb to carefully guide the presser foot into the correct
position and it will snap into place.

ATTACHING THE EDGE/QUILTING GUIDE

Attach the edge/quilting guide in the slot (A) as illustrated.
Adjust as needed for hems, pleats, quilting, etc.
Turn power switch to off ("O") when carrying out any of the
above operations!
16 – Preparations
1
2
A