Threading The Upper Thread - Husqvarna VIKING Onyx 15 User Manual

THREADING THE UPPER THREAD

Important! Make sure that the presser foot is raised and the
needle is in its highest position by turning the handwheel
toward you. This is very important to help ensure that the
machine is correctly threaded. Not doing so can result in poor
stitch quality when you start to sew.
1. Place the thread on the spool pin and fit the appropriately
sized spool cap.
2. Pull the thread into the thread guide (A) from front to
the back and thread guide (B) from back to front. Pull the
thread between the tension discs (C).
3. Continue bringing the thread down through the right thre-
ading slot, around the U-turn, then back upwards through
the left threading slot.
A
B
D
C
Machine from above
12 – Preparations
4. Bring the thread from the right into the take-up lever (D)
and down in the left-hand threading slot, into the lower
thread guide (E) and to the needle thread guide (F).
5. Thread the needle from front to back.
Machine from front
E
F