Lenovo ThinkStation P5 Manual page 34

5. Install the 3 rd Drive bay mount next to the FLEX bay base. Locate the offset
mount holes (1) next to the FLEX bay base and the mounting point (2) on
the front of the chassis wall.
6. Align the bumps on the bottom of the 3
mount holes (1) and insure that the notch on the mount rests in the
mounting point on the front of the chassis wall (2).
7. When the drive mount is seated properly install the two screws into the
mount base, on either side of the indents, securing it to the chassis.
8. Remove the drive carrier from the 3
handle and lifting the tray up out of the tray.
rd
Drive bay mount with the offset
rd Drive Bay tray by pulling in on the red
34