Table of Contents
Advertisement
Adjusting the waveform
Project the luminance adjustment signal of a commercial test disk (0 % (0 IRE or 7.5 IRE) – 100 % (100 IRE)) and
adjust.
1)
Select "Select line (luminance)" on the waveform monitor.
2)
Adjust black level.
f Adjust the black level 0 % of the video signal to the 0 % position of the waveform monitor using the
[PICTURE] menu → [BRIGHTNESS].
3)
Adjust white level.
f Adjust the white level 100 % of the video signal to the 100 % position of the waveform monitor using the
[PICTURE] menu → [CONTRAST].
Adjusting red, green, and blue
1)
Set [COLOR TEMPERATURE] to [USER]. (x page 78)
2)
Select "Select line (red)" on the waveform monitor.
3)
Adjust dark red areas.
f Use [RED] in [WHITE BALANCE LOW] to adjust the black level 0 % of the video signal to the 0 % position
of the waveform monitor.
4)
Adjust bright red areas.
f Use [RED] in [WHITE BALANCE HIGH] to adjust the white level 100 % of the video signal to the 100 %
position of the waveform monitor.
5)
Use the procedure for [RED] to adjust [GREEN] and [BLUE].
Note
f Confirm that the [SIGNAL LEVEL] setting of the input signal is correct before adjusting the black level.
Check the [SIGNAL LEVEL] setting in the [DISPLAY OPTION] menu → [HDMI 输入]/[DVI-D 输入]/[SDI 输入]/[DIGITAL LINK 输入] →
[SIGNAL LEVEL].
Chapter 4 Settings — [DISPLAY OPTION] menu
Image position
Image displayable area
ENGLISH - 117
Advertisement
Table of Contents
