Table of Contents
Advertisement
Available languages
Available languages
Fig. D
15
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from power
source and remove the battery pack before
making any adjustments or removing/installing
attachments or accessories. An accidental start‑up
can cause injury.
Installing and Removing the Battery Pack
(Fig. E)
WARNING: Ensure the appliance is in the off position
before inserting the battery pack.
WARNING: Appliance will slide forward when inserting
battery, which may cause serious injury, as well as
damage the appliance.
nOTE: For best results, make sure your battery pack is
fully charged.
nOTE: Ensure the battery compartment door
unless inserting or removing battery pack
1. Remove bottles before inserting battery pack as
described in the REMOVING BOTTLES section.
2. To install the battery pack into the appliance:
a. Lift the battery compartment door and align
the battery pack with the rails inside the battery
compartment
3
.
b. Place your other hand on the front of the bottle
platform
12
to keep the appliance from sliding.
c. Slide the battery pack in until it is firmly seated in the
appliance, and ensure that it does not disengage.
3. To remove the battery pack from the appliance, press the
battery release button
out of the appliance.
17
19
13
4
is closed
1
.
and firmly pull the battery pack
2
Fig. E
12
On/Off (Fig. F)
WARNING: Do not interact with the cocktail maker
while it is operating.
•
The cocktail maker can be operated with:
‑
Just the battery pack installed
‑
Just the power supply plugged in
‑
Battery pack installed and power supply plugged in.
This will also charge the battery pack.
•
To turn the cocktail maker on, push the "I" side of the power
switch
20
. The 4 strength LEDs
will blink. When they become solid, the cocktail maker is
ready to use.
•
To turn the cocktail maker off, push the "O" side of the power
switch. All LEDs will turn off.
Fig. F
Choose a Glass Tray (Fig. G)
Place a glass or shaker on either the glass shelf
tray cover
9
, depending on the height of the glass being
used. Refer to the cocktail image on the capsule
glass style.
nOTE: A glass or shaker must be in place before making a
drink to avoid spillage.
short glass:
1. Pull the glass shelf down so it stands straight out from
the tower
25
.
2. Place a small glass on the glass shelf.
Tall glass:
1. Push the glass shelf up so it hides away in the tower.
2. Ensure the drip tray cover is in place.
3. Place a tall glass on the drip tray cover.
shaker:
The shaker LED
23
will light when a drink needs to be
shaken. In this case, use a shaker instead of a tall glass.
1. Push the glass shelf up so it hides away in the tower.
2. Ensure the drip tray cover is in place.
English
4
1
2
3
22
and 6 bottle LEDs
24
20
11
or drip
26
for
7
Advertisement
Table of Contents
