Maintenance - Black & Decker BEV BCHB101 Instruction Manual

English
Fig. K
35

MAINTENANCE


WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from power
source and remove the battery pack before
making any adjustments or removing/installing
attachments or accessories. An accidental start‑up
can cause injury.
Your BLACK+DECKER appliance has been designed to
operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends
upon proper appliance care and regular cleaning.
Cleaning (Fig. L)

WARNING: Turn unit off and disconnect it from
power source and remove the battery pack before
cleaning appliance.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non‑metallic parts of the
appliance. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid get
inside the appliance; never immerse any part of the
appliance into a liquid.

CAUTION: Straws, bottle stoppers, capsule cup,
drip tray insert, drip tray cover, and water bottle are
top‑rack dishwasher safe. It is recommended that you
manually rinse the attachments before placing them in
the dishwasher.
• Clean the inside of the straws with warm water, mild
soap, and the provided straw cleaner
• Clean all external parts with a cloth dampened with warm
water and mild soap.
• To clean the capsule cup
and out of the capsule holder
slide it into the capsule holder and press down. Ensure
the cup sits fully and securely inside the capsule holder.
10
38 .
29 , remove it by pulling it up
27 . To reinstall the cup,
Fig. L
29
Cleaning Mode (Fig. D, H, L, M)
It is recommended to clean the liquid lines of the cocktail
maker at least once a month.
1. Turn the cocktail maker on as described in the ON/OFF section.
2. Remove the capsule
Ensure the capsule cup
3. Place a large glass that holds at least 10 oz (300 ml) on
the drip tray 7 .
4. Remove the bottles as described in the REMOVING
BOTTLES section.
5. Fill a glass with at least 2 oz (60 ml) of water.
6. Place a straw in the glass and install the straw as
13
described in the INSTALLING BOTTLES section.
7. Repeat steps 1 ‑ 5 for all bottles.
8. Press the cleaning mode button
9. Once the unit starts pumping water, let go of the
cleaning mode button.
Fig. M
10. The bottle LEDs 24 will light one at a time to indicate
which line is being cleaned. Once all LEDs turn on, the
process is complete.
11. Water may splash on the barcode scanner
a clean, dry towel to wipe the barcode scanner and
surrounding area.
12. Install the bottles as described in the INSTALLING
BOTTLES section.
27
26 from the capsule holder
29 remains in place.
36 for 3 seconds.
36
40
27 .
. Use