Table of Contents
Advertisement
Hold the machine with both hands. While operating the
machine, adjust the switch trigger so that the suction
force is appropriate for the work location and conditions.
Empty the dust bag before it becomes too full by removing the
dust bag from the machine, and then removing the fastener.
► 1. Fastener
TROUBLESHOOTING
Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual, do not attempt
to dismantle the machine. Instead, ask Makita Authorized Service Centers, always using Makita replacement parts for repairs.
State of abnormality
Motor does not run.
Motor stops running after a little
use.
The machine does not reach the
maximum speed.
Abnormal vibration:
stop the machine immediately!
Motor cannot stop:
Remove the battery immediately!
1
Probable cause (malfunction)
Battery cartridge is not installed.
Battery problem (under voltage)
The drive system does not work correctly.
Battery's charge level is low.
Overheating.
Battery is installed improperly.
Battery power is dropping.
The drive system does not work correctly.
The drive system does not work
correctly.
Electric or electronic malfunction.
11 ENGLISH
MAINTENANCE
CAUTION:
Always be sure that the machine is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Cleaning the machine
Clean the machine by wiping off dust with a dry cloth or
one dipped in soapy water and wrung out.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Remove dust or dirt from the suction inlets.
1
1
► 1. Suction inlet
Remedy
Install the battery cartridge.
Recharge the battery. If recharging is not effective, replace battery.
Ask your local authorized service center for repair.
Recharge the battery. If recharging is not effective, replace battery.
Stop using the machine to allow it to cool down.
Install the battery cartridge as described in this manual.
Recharge the battery. If recharging is not effective, replace battery.
Ask your local authorized service center for repair.
Ask your local authorized service center for repair.
Remove the battery and ask your local authorized
service center for repair.
Advertisement
Table of Contents
