Receiving A Dsc Position Report Call - Standard Horizon MATRIX Series Owner's Manual

DSC Position Report Call Manually Entering an MMSI
This feature allows you to send your position to another vessel by manually
entering the MMSI of the ship you want to send your position to.
1. Press the
appear.
2. Rotate the CH knob to select " POS REPORT ".
(To cancel, press the
3. Press the
will beep, and the POS report call menu will
appear.
4. Rotate the CH knob to select " MANUAL ",
then press the
5. Rotate the CH knob to select the first
number of the MMSI which you want to
contact, then press the
step to the next number.
6. Repeat step 5 to set the MMSI number.
If a mistake was made entering in the MMSI
number, repeatedly press the
key until the wrong number is selected,
then rotate the CH knob to correct the entry.
7. When finished entering the MMSI number,
press and hold the
8. Press the
9. Press the

9.8.2 Receiving a DSC Position Report Call

When another vessel transmits their vessels location to the GX2000/GX2150
the following will happen:
1. A ringing sound will be produced when the call is
received and NMEA sentences (DSC, DSE) are
outputted so the position can be shown on a chart
plotter or a computer.
2. Press any key to stop ringing.
3. Rotate the CH knob to see position information of the station.
4. To exit to radio mode, press the
Page 74
key. The " DSC Menu " will
CALL
MENU
soft key.)
soft key. The transceiver
soft key.
soft key.
soft key to send your position to the selected vessel.
soft key to return to radio operation.
-POS Report Call-
Input MMSI
ID:---------
SELECT
soft key to
-POS Report Call-
Category:Routine
YES
soft
soft key.
-POS Report Call-
BACK QUIT
Input MMSI
ID:345678901
Name:
SELECT BACK
ID:345678901
-POS Report Call-
Transmit?
Name:
ID:345678901
QUIT
Category:Routine
Transmiting
Received POS REPORT
Name:Horizon
ID:123456789
Category:Routine
Since: 01:03
-POS INFO-
TO WPT SAVE
GX2000/GX2150
QUIT
QUIT