6.10 CHANGING COG TO TRUE OR MAGNETIC
Allows the GPS COG (Course Over Ground) and the BRG from an AIS target
to be selected to show in True or Magnetic. Factory default is "True" however
by following the steps below the COG can be changed to "Magnetic".
1. Press and hold the
appears, then select " GENERAL SETUP " with the
CH knob.
2. Press the
knob to select " MAGNETIC ".
3. Press the
4. Rotate the CH knob to select " M A G N E T I C " or
" TRUE ".
5. Press the
setting.
6. Press the
radio operation.
6.11 OPTIONAL CMP31 ( RAM3+ ) INSTALLATION
The GX2000/GX2150 is capable of using a CMP31 ( RAM3+ ) Remote Station
Microphone to remotely control the Radio, AIS, DSC and PA/Fog functions.
In addition the GX2000/GX2150 can operate as a full function intercom
system between the CMP31 ( RAM3+ ) and the GX2000/GX2150.
1. Connect the extension cable to
the remote microphone eight
pin connector on the rear panel,
then tighten the cable nut (see
illustration at the right).
2. Install the ferrite core (supplied with the CMP31 ( RAM3+ ) Remote
Station Microphone) to the extension cable, then snap its two halves
together, per the illustration on the next page.
3. Attach the ferrite core as close as possible to the MIC plug, as shown
below.
4. Finally, wind some plastic tape
around each ferrite core, to
prevent vibration from causing
the two halves to split apart.
GX2000/GX2150
key until " Setup Menu "
CALL
MENU
soft key, then rotate the CH
soft key.
soft key to store the selected
soft key two times to return to
External Speaker
Connections
Routing Cable or
CT-100 Extension Cable
As close as possible
-Magnetic-
TRUE
Magnetic
ENT
QUIT
Ferrite Core
Snap together
Page 25