17
TUNING THE ENGINE
17.11
Engine characteristic - setting the auxiliary spring
Warning
Danger of burns Some vehicle components become very hot when the vehicle is operated.
–
Do not touch hot components such as exhaust system, radiator, engine, shock absorber, and the brake system. Allow these
components to cool down before starting work on them.
2
0 0 2
3
0 0 3
4
0 0 0 4
Preparatory work
–
Tilt the motorcycle approx. 45º to the left and secure it to prevent it from falling.
Main work
–
Remove screws
L01660-10
–
Take cap
the clutch cover.
–
Pull both springs off of the spring insert.
0 0 5
5
B00056-11
–
Mount the required auxiliary spring
the clutch cover together.
Auxiliary spring with yellow marking (54637072300)
Auxiliary spring with green marking (54837072100)
Auxiliary spring with red marking (54837072000)
L02608-10
–
Check the O-ring in the cap.
–
Position the cap.
–
Mount and tighten the screws.
Guideline
Screw, exhaust control cover
(All TE 250/300)
.
, adjusting spring
The cut-out of spring insert
Info
Screw
must not be turned as this would worsen the engine characteristic.
, auxiliary spring
, and spring insert
and adjusting spring
engages in the angle lever.
M5
97
out of
and slide them into
6 Nm (4.4 lbf ft)