15
ELECTRICAL SYSTEM
15.10
Adjusting the headlight range
15.11
Changing the speedometer battery
»
If the light-dark border does not meet specifications:
–
Adjust the headlight range. (
Preparatory work
–
Check the headlight setting. (
Main work
–
Loosen screw
–
Adjust the headlight range by pivoting the headlight.
Guideline
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with a rider (instructions on how to apply the mark: Checking the head-
light setting).
Info
S00506-10
A change in weight on the vehicle may require a correction of the headlight
range.
–
Tighten screw
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
Main work
–
Remove screws
–
Pull the speedometer upward out of the holder.
L02605-10
–
Using a coin, turn protection cap
–
Remove speedometer battery
–
Insert the new battery with the label facing outward.
Speedometer battery (CR 2032)
–
Check the O-ring of the protection cap for correct seating.
B01644-11
–
Position protection cap
–
Press any button on the speedometer.
The speedometer is activated.
–
Position the speedometer in the holder.
–
Mount and tighten the screws with washers.
B01645-11
Finishing work
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
–
Set the speedometer. (
p. 87)
p. 86)
.
.
.
all the way counterclockwise and remove it.
.
and turn all the way clockwise using a coin.
p. 86)
p. 21)
p. 83)
p. 84)
87