Troubleshooting; Initial Setup; Initial Cleaning - Samsung BQ1VD6T131 User Manual

Hide thumbs Also See for BQ1VD6T131:
Table of Contents

Advertisement

iniTial sETup

initial cleaning

Before the oven is used for the first time, it should be cleaned thoroughly. Do not use any abrasive
cleaning agents, cloths or substances, because they could damage the oven surfaces.
Use warm water, detergent and soft clean cloth to clean the baking tray, dripping tray, grids and
the other accessories, as well as the internal compartment and the guide rails at the oven sides.
The front should be cleaned with damp, soft and clean cloth.
Check if the oven clock is set correctly and remove all accessories from the oven. Run oven
in single mode with convection for one hour at 200 °C. This procedure will burn any remaining
production substances in the oven with an unmistakeable odour. This is normal, though make sure
your kitchen is well ventilated during that time.

TrOuBlEsHOOTing

PROBLEM
What should i do if the oven
doesn't heat up?
What should i do if the oven
doesn't heat up even after the
function and temperature have
been set?
What should i do if an error
code appears and the oven
does not heat up?
1)
**
What should i do if the time
display is blinking?
What should i do if the oven
light doesn't illuminate?
What should i do if the oven's
fan is running without having
been set?
infOrMaTiOn cODEs
CODE
PROBLEM
Safety shut off. The oven continues
operating at the set temperature for a
1)
**
prolonged time.
Key is pressed for over 10 seconds.
1)
**
Divider Missing. Divider use is incorrect.
An oven error may cause low
1)
**
performance and problems in safety.
Stop using the oven immediately.
1) ** refers to all numbers.
22_installation & maintenance
BQ1VD6T131-XEU_00382R-EN.indd 22
SOLUTION
• The oven may not be switched on. Switch the oven on.
• The clock may not be set. Set the clock.
• Check to see if the required settings have been applied.
• A household fuse may have blown or a circuit breaker
may has tripped.
Replace the fuses or reset the circuit. If this happens
repeatedly, call an electrician.
• There may be problems with the internal electrical
connections. Call your local service centre.
• There is a fault in the internal electrical circuit
connection. Call your local service centre.
• There has been a power failure. Set the clock.
• The oven light is faulty. Call your local service centre.
• After use, the oven's fan runs until the oven has cooled
down. Call your local service centre if the fan continues
to run after the oven has cooled down.
SOLUTION
Turn oven off and remove food. Allow
oven to cool before using it again.
Call your local SAMSUNG Customer Care
Centre.
Insert divider for upper, twin and lower
mode. Remove divider for single mode.
Call your local SAMSUNG Customer Care
Centre.
2011-07-04
3:36:19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents