Table of Contents
Advertisement
Chapter 1: Introduction
The settings in this guide were specified by FedEx Office Asset Management for use
across all imagePRESS C750 devices in their fleet that are in a Full-Service
environment.
Important
Any device that is removed from a FedEx Office center, must have its Hard Disk
Drive erased using the single-pass process native to the device. The Fiery must
have a [Clear Server] performed. This can be done by running setup from
Command WorkStation. A form that confirms this is in the Appendix of this guide,
and should be signed by the Center Manager and the Technician before it is sent to
the e-mail address on the form. It is acceptable to leave a copy of the form with the
Center Manager, if he/she requests it.
Important
It is essential that any device installed in a FedEx Office center is configured to the
specifications identified in this Guide. As a result the imagePRESS C750
Configuration and Installation Guide applies long after the installation has been
completed and should be used to perform updates.
Important
FedEx Office Asset Management planners have confirmed the installation date and
the devices to be removed with the Center Manager and their District Manager. If you
are asked to deviate from the installation plan in any way, for example, delaying
the installation to another day, leaving a legacy device rather than picking it up,
delaying removal or clearing of the HDD for more than a reasonable amount of
time, or using settings that are different from what is contained in this Guide,
inform the FedEx Office Center Manager to contact their District Manager or
their Asset Management Team at FedEx Office Headquarters for approval.
Important
Upon completion of the installation, a Fiery Configuration Page must be printed. See
the procedure in Chapter 12, "Post Installation Actions." Also, the imagePRESS C750
Post Installation Checklist, the Certification of Canon Machine Hard Disk Drive
Erase, and the
Training Checklist for the imagePRESS C750, must be signed by the
Technician and Center Manager (or their designee). The Technician must then scan all
four documents into one PDF file, and e-mail them to:
fxo_order_management@cusa.canon.com.
If the Center Manager (or their designee) refuses to sign any of these documents, you
should indicate this refusal to sign on the bottom of the particular form.
imagePRESS C750 with imagePRESS Server G100 Configuration and Installation Guide
4
Advertisement
Table of Contents
