Hitachi Relion 670 Series Operation Manual page 51

1MRK500127-UUS Rev. M
GUID-8A573707-899E-4F4C-B20A-931D1556F480 V1 EN-US
Figure 28:
2.
Press
One press increases or decreases the value by a certain step. For integer values, the change is 1,
10, 100 or 1000 (...) depending on the active digit. For decimal values, the change can be fractions
0.1, 0.01, 0.001 (...) depending on the active digit.
3.
Press
4. To select the minimum or maximum value, select the arrow symbol in front of the value.
•
•
If the value is already at either end value (minimum or maximum), it requires two presses to change
it to the opposite end value.
After pressing
Another press of
value is ↕, when the previous value is shown.
670 series
Operation manual
Last digit is active and it can be increased or decreased
to increase or to decrease the value of an active digit.
For parameters with defined steps, digits smaller than the step value cannot be edited.
or to move the cursor to another digit.
To set the value to the maximum, press
To set the value to the minimum, press
, the previous value can be restored by pressing
or sets the value to the lower or higher limit. The symbol in front of the
© 2017 - 2023 Hitachi Energy. All rights reserved
IEC13000285-1-en.vsd
.
.
Section 5
Using the HMI
once, and vice versa.
45