Philips AquaTrio Cordless 7000 Series User Manual page 25

Problem
The floor is less wet than
usual, or one side of the floor
under the nozzle is less wet
than the other one.
There is no water on the
floor.
There is more water on the
floor or in the After-Clean
tray than usual.
The appliance leaves water
traces on the floor.
Possible cause
One or both wetting strips may
be blocked.
The clean water tank is empty.
The wetting strips are blocked.
The water channel of the wet
module and/or AquaSpin
nozzle is polluted or blocked.
The dirty water tank is not
placed correctly.
You have moved the appliance
sideways.
You made strong turns with
the appliance.
You have moved the appliance
across a threshold while it was
switched on.
Solution
Remove the two microfiber brushes, fill
some water into the clean water tank and
switch the appliance on. Make small
forward and backward movements on the
same position for around 15 seconds. You
should be able to see four water stripes on
the floor. If this is not the case, or if one or
more water stripes only consist out of a few
droplets, the wetting strips are partially or
fully blocked and you can rinse them under
the tap. If that does not help, you can try to
carefully open the holes with a needle.
Refill the clean water tank.
Remove the two microfiber brushes, fill the
clean water tank with some water, and
switch the appliance on. Make small
forward and backward movements on the
same position for around 15 seconds. You
should be able to see four water stripes on
the floor. If this is not the case, or if one or
more water stripes only consist out of a few
droplets, the wetting strips are partially or
fully blocked and you can rinse them under
the tap. If that does not help, you can try to
carefully open the holes with a needle.
If you have checked the above and there is
still no water on the floor, take the
appliance to a Philips service center or
contact the Consumer Care Center.
Use the cleaning brush and clean the water
channel of the wet module and/or
AquaSpin nozzle (see 'Removing blockages
from the appliance').
Place the dirty water tank into the
appliance properly. It is closed correctly
when you can hear a 'click' sound.
Only move the appliance forwards and
backwards.
Try to make less strong turns with the
appliance.
Make sure the microfiber brushes stay in
contact with the floor. Make sure water
absorption mode is switched on before
you lift the appliance over a threshold,
carpet or stairs to prevent water traces on
English
25