Replacing The Lamp; Closing The Door; Technical Data; Installation - AEG S75348KG18 User Manual

Replacing the lamp

CAUTION!
Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.
2. Pull outwards the hook of the lamp cov-
er.
3. Remove the lamp cover.
4. Replace the lamp with one of the same
power (the maximum power is shown on
the light bulb cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the plug to the mains socket.
8. Open the door. Make sure that the light
comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Force Center.

Technical data

Dimension
Rising Time
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.

Installation

WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the ap-
pliance before installing the appliance.

Positioning

Install this appliance at a location where the ambient temperature corresponds to the
climate class indicated on the rating plate of the appliance:
Height
Width
Depth
2
S75348KG18
1850 mm
595 mm
632 mm
18 h
Technical data
1
3
S75388KG18
2010 mm
595 mm
632 mm
18 h
17