Table of Contents
Advertisement
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Topics:
•
Procedure
•
Post-requisites
Procedure
1. Place the I/O board on the palm-rest assembly.
2. Align the screw holes on the I/O board with the screw holes on the palm-rest assembly.
3. Replace the two screws (M2x3) that secure the I/O board to the palm-rest assembly.
4. Connect the coin-cell battery cable to the I/O board.
5. Slide the I/O-board cable into the connector on the I/O board and close the latch to secure the cable.
6. Adhere the tape that secures the I/O-board cable to the I/O board.
Post-requisites
1. Replace the
wireless
card.
2. Replace the
base
cover.
Replacing the I/O board
computer. After working inside your computer, follow the instructions in
26
After
www.dell.com/
Replacing the I/O board
41
Advertisement
Table of Contents
