Yamaha Grizzly 700 2011 Manual page 124

6. Remove the radiator cap.
1. Radiator cap
7. Remove the coolant reservoir cap.
8. Disconnect the coolant reservoir hose on the
8
coolant reservoir side, and then drain the cool-
ant from the coolant reservoir.
1. Coolant reservoir hose
9. After draining the coolant, thoroughly flush the
cooling system with clean tap water.
10. Install the coolant drain bolt and its new gas-
ket, and then tighten the bolt to the specified
torque.
Tightening torque:
Coolant drain bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
11. Connect the coolant reservoir hose.
12. Pour the recommended coolant into the radia-
tor until it is full.
8-35