Makita DTW300 Instruction Manual page 7

Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
Fig.2: 1. Indicator lamps 2. Check button
light up for a few seconds.
Indicator lamps
Lighted
NOTE: Depending on the conditions of use and the
Switch action
Fig.3: 1. Switch trigger
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
trigger. Release the switch trigger to stop.
NOTE:
pulling the switch trigger for 6 minutes.
NOTE: When full speed mode is turned on, the rota-
For detail information, refer to the section of full speed
mode.
Lighting up the front lamp
-
To turn on the lamp status, press the button
Remaining
capacity ton
With the lamp status ON, pull the switch trigger to turn
Blinking
75% to 100%
trigger.
With the lamp status OFF, the lamp does not turn on
50% to 75%
even if pulling the trigger.
25% to 50%
0% to 25%
Charge the
malfunctioned.
Reversing switch action
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
7 ENGLISH
CAUTION:
Do not look in the light or see the
source of light directly.
Fig.4: 1. Lamp
Fig.5: 1. Button
for one second again.
NOTE:
the lamp status is ON. When the lamp does not come
on, the lamp status is OFF.
NOTE:
this case, cool down the tool before operating again.
NOTE:
the lamp. Be careful not to scratch the lens of lamp, or
NOTE: While pulling the switch trigger, the lamp
status cannot be changed.
NOTE:
the switch trigger, the lamp status can be changed.
Fig.6: 1. Reversing switch lever
CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
Use the reversing switch only after
the tool comes to a complete stop. Changing the
age the tool.
CAUTION:
When not operating the tool,
always set the reversing switch lever to the neu-
tral position.
for
-
-