NETGEAR WGR613VAL Manual page 16

NETGEAR Wireless Router Setup Manual
Figure 3-4: Verify the connections according to the status lights on the wireless router
Check the wireless router status lights to verify the following:
d.
• Power: The power light should turn solid green. If it does not, see
Tips" on page
• Test: The test light should be off. The test light blinks when the router is first turned on
then goes off. If after 2 minutes it is still on, see the Troubleshooting Tips below.
• Internet: The Internet port light should be lit. If not, make sure the Ethernet cable is
securely attached to the wireless router Internet port and the modem, and the modem
is powered on.
• Wireless: The wireless lights should be lit. If not, see
3-7.
• LAN: A LAN light should be lit. Green indicates your computer is communicating at
100 Mbps; yellow indicates 10 Mbps. If a LAN light is not lit, check that the Ethernet
cable from the computer to the router is securely attached at both ends, and that the
computer is turned on.
• Phone: The Phone light will not be lit until your phone service provider provisions the
phone service. Check the user guide from your phone service provider for details on
provisioning the phone service.
3-4
3-7.
September 2004
"Troubleshooting
"Troubleshooting Tips" on page
Connecting the Router to the Internet