NETGEAR WGR613VAL Manual page 15

Securely insert the cable that came with your wireless router (the NETGEAR cable in the
f.
diagram below) into a LAN port on the router such as LAN port 4 (point C in the
diagram), and the other end into the Ethernet port of your computer (point D in the
diagram).
D
Figure 3-3: Connect the computer to the wireless router
If you have a voice service or plan to order it, connect a telephone to Phone Port 1 on the
wireless router using a standard phone cord (not included).
Your network cables are connected and you are ready to restart your network.
2. R
ESTART YOUR NETWORK IN THE CORRECT SEQUENCE
Warning: Failure to restart your network in the correct sequence could prevent you from
connecting to the Internet.
First, plug in and turn on the broadband modem. Wait about 2 minutes.
a.
Now, plug in the power cord to your wireless router. Wait about 2 minutes.
b.
Last, turn on your computer.
c.
Note: For DSL customers, if software logs you in to the Internet, do not run that software. You
may need to go to the Internet Explorer Tools menu, Internet Options, Connections tab page
where you can select "Never dial a connection."
Connecting the Router to the Internet
C
September 2004
NETGEAR Wireless Router Setup Manual
3-3