NETGEAR WGR615VV2 Manual page 18

NETGEAR Wireless Router Setup Manual
After logging in to the router, you will see the Internet connection Smart Wizard on the
settings main page.
Use the Smart Wizard to Configure Your Wireless Router
You are now connected to the router. If you do not see the menu above, click the Setup Wizard
1.
link on the upper left of the main menu.
Click Next to proceed. Input your ISP settings, as needed.
2.
Note: If you choose not to use the Setup Smart Wizard, you can manually configure your
Internet connection settings by following the procedures in the Setup Manual on the CD.
Unless your ISP automatically assigns your configuration automatically via DHCP, you will
need the configuration parameters from your ISP.
When the router successfully detects an active Internet service, the router's Internet LED goes
3.
on. The Setup Smart Wizard reports which connection type it discovered, and displays the
appropriate configuration menu. If the Setup Smart Wizard finds no connection, you will be
prompted to check the physical connection between your router and the cable or DSL modem.
The Setup Smart Wizard will report the type of connection it finds and prompts you for the
4.
settings.
At the end of the Setup Wizard, click the Test button to verify your Internet connection and
5.
register your product. If you have trouble connecting to the Internet, use the Basic Setup
Troubleshooting Tips below to correct basic problems, or refer to the Setup Manual on the CD.
You are now connected to the Internet and the wireless feature of the wireless router is
enabled! Next, configure your wireless computer.
3-6 Connecting the Router to the Internet
September 2004