NETGEAR WGR615VV2 Manual page 17

3. O
PEN A BROWSER AND LOG IN TO THE ROUTER
For DSL customers, if your Internet service provider had you install software logs you in to the
Internet, do not run that software. If such software automatically starts when you open a browser,
you may need to go to the Internet Explorer Tools menu, Internet Options, Connections tab page
where you can select "Never dial a connection."
From the Ethernet connected computer you just set up, open a browser such as Internet
1.
Explorer or Netscape® Navigator.
Note: If your browser connects you to the Internet, you can skip this section and proceed to the
Now, Set Up a Computer for Wireless Connectivity
Connect to the wireless router by typing http://192.168.61.1 in the address field of your
2.
browser, then click Enter.
For security reasons, the router has its own user name and password. When prompted, enter
3.
for the router user name and
admin
letters.
Note: The router user name and password are not the same as any user name or password you
may use to log in to your Internet connection.
A login window like the one shown below opens:
Figure 3-5: Login window
Note: If you cannot connect to the wireless router, verify your cables are connected correctly,
that the router is powered on, and that the networking setup of your computer is set to obtain
its settings automatically via DHCP. It should be set to obtain both IP and DNS server
addresses automatically, which is usually so. For help with this, please see the tutorials on the
CD.
Connecting the Router to the Internet
NETGEAR Wireless Router Setup Manual
section below.
for the router password, both in lower case
password
September 2004
3-5