About Demo Mode - Pioneer DDJ-SR Service Manual

1
Note on Replacement of the Pad & FSR Plate Assy
A
Four washers have been added to the screw-mounted parts of the Pad & FSR Plate Assy to solve the problem that
a performance pad is only pressed halfway although it is fully pressed. This problem was revealed during production.
This emergency measure will be taken care of in the future, but the exact date when the improved products will be produced is
not determined yet. At least the first 20,000 products will have the added washers.
The initial service parts for the Pad & FSR Plate Assy will also require attachment of washers.
To prevent the washers from not being attached during replacement of the Pad & FSR Plate Assy with the one for service,
the Pad & FSR Plate Assy and the washers are to be enclosed in the same package as a kit.
The part number of the kit for service is GXX1374.
When a new Pad & FSR Plate Assy for service is to be reassembled, be sure to attach the enclosed 4 washers to
the screw-mounted parts. (See the figure below.)
B
C
D

1.3 ABOUT DEMO MODE

This unit will automatically enter Demo mode if it is left unoperated for 10 minutes in Normal Operation mode, and a
demonstration with LED illumination will start.
To cancel this mode, operate any control or button of this unit.
To disable Demo mode, change the setting in the settings of Utilities mode 1. (For details, refer to the operating instructions.)
E
F
4
1
2
Pad & FSR Plate Assy
2
3
Attach the washer.
DDJ-SR
3
4
4