Pioneer DDJ-SR Service Manual page 25

5
Result
+1 from the reference value A/D conversion value
+2 from the reference value A/D conversion value
+3 from the reference value A/D conversion value
+4 from the reference value A/D conversion value
Over +5 From the reference value A/D conversion value
-1 from the reference value A/D conversion value
-2 from the reference value A/D conversion value
-3 from the reference value A/D conversion value
-4 from the reference value A/D conversion value
Less than -5 from the reference value A/D conversion value
* Display at the same time both fall / rise direction from the reference value of the conversion value A/D.
Level indicator
5 By pushing the Rotary selector while monitoring the conversion value A/D, it is possible to reset the state of the fluctuations
of the past.
Ex.)
1. Turn EQ HI knob (for DECK 1) to the position you want to
measure.
DECK1
2. Turn the Rotary selector until the 7th LED (Performance
pad) lights.
3. Start A/D conversion value monitoring to push Rotary
selector. If A/D value of push the Rotary selector is 760,
to monitor the amount of change in the value of A/D as
a reference value 760.
4. After a while, Level indicator is lit as follows:
become the value 763 of the A/D.
5. More time has elapsed, to maintain the above display
762 even though the value of the A/D.
6. More time has elapsed, Level indicator is lit as
follows: become the value 764 of the A/D.
5
6
Fig No.
1
2
3
4
5
6
7
8
9
10
1 2 3 4
* Keep the lighting position at the time of maximum fluctuation of each of the positive & negative direction
DDJ-SR
6
7
5 6 7 8
7. More time has elapsed, Level indicator is lit as
follows: become the value 758 of the A/D.
8. More time has elapsed, To maintain the above display
759 even though the value of the A/D.
9. More time has elapsed, Level indicator is lit as
follows: become the value 757 of the A/D.
10. Off all the LED on Level indicator When you push
the Rotary selector, and this value will be new reference
value.
7
8
A
B
9 10
C
D
E
F
25
8