Rebooting The Unit; Logging Out - Cisco FLUIDMESH FM3200 Endo Installation And Configuration Manual

Backhaul FM3200 Endo Cisco Ultra-Reliable Wireless

Rebooting the unit

The reboot window contains controls that allow you to reboot the Cisco
FM3200 Endo (in other words, to re-start the unit's operating system).
To reboot the unit, do the following steps:
1. Click the -reboot link under MANAGEMENT SETTINGS in the
left-hand settings menu.
• The unit reboot dialog will be shown
2. Reboot the unit by clicking the YES link. Alternatively, abort the
reboot by clicking the NO link.
• If the YES link was clicked, the unit will reboot.

7.7.8. Logging out

If clicked, the logout option logs the current user off the unit, and out of the
Configurator interface.
• To log out, click the -logout link under MANAGEMENT
SETTINGS in the left-hand settings menu.
• You will be logged off the unit and out of the Configurator
• The web browser will show the Authentication Required
© 2020 Cisco and/or its affiliates. All rights reserved.
140)).
Figure 62. Configurator GUI (unit reboot dialog)
interface with no further prompting.
dialog (Figure 63 (page
log in again.
Figure 63. Web browser (Authentication Required
dialog)
(Figure 62 (page
140)). If needed, use the dialog to
Page 140 of 177