Honeywell NOTIFIER INSPIRE E10 Operating Instructions Manual page 14

Day or Night Mode operation
This is a Toggle function, if configured for your system, will allow a change between Day Mode and Night Mode.
The Day Mode is made active on preselected days of the week over preselected time period. Outside the Day
Mode the Night mode is automatically made active.
When the Day mode is active the 'Delay Active' LED is lit
The switch between Day mode and Night mode is possible using the Toggle button during Normal
'SAFE' condition. During event condition such as with an active Fault or Disablement event, then this
toggle functionality is accessible using the menu, see "Day/Night Mode Settings" on
Day mode
During the Day Mode and upon detection of a Fire the activation of alarm output is delayed to allow the incidence
to be investigated. When the Verification Delay button is pressed then the initial investigation delay ends and
verification delay starts.
Any active delay can be stopped by selecting the
Night Mode
In the Night Mode the sensors operate normally and upon detection of fire the alarm outputs are activated
without delay.
At any time to toggle between Day Mode and Night Mode see page 30.
VdS default configuration
The Day mode may need to be enabled manually. A VdS approved default configuration will cause auto
delay to be deactivated on entry into Night mode, so manual intervention is required to activate Day
mode.
14
and the LED is Off during Night Mode
button.
page 29..