Table of Contents
Advertisement
Available languages
Available languages
Important Safety Instructions for All Integral Battery Charging
WARNING: Read all safety warnings, instructions, and cautionary markings for
the battery, cable and product. Failure to follow the warnings and instructions
may result in electric shock, fire and/or serious injury.
•
The provided charging cable is not intended for any uses other than charging
BLACK+DECKER rechargeable products with micro USB ports. Charging other types
of products may cause their batteries to overheat and burst, resulting in personal
injury, property damage, fire, electric shock or electrocution.
•
Use only with the Listed/Certified Information Technology Equipment (e.g. computer).
•
DO NOT expose charging cable to water, rain or snow.
•
Pull by the plugs rather than the cord when disconnecting the charging cable. This
will reduce the risk of damage to the plugs and cord.
•
Make sure that the cord is located so that it will not be stepped on, tripped over or
otherwise subjected to damage or stress.
•
When charging the product outdoors, always provide a dry location.
•
DO NOT use a charging cable with a damaged cord or plugs. Have them
replaced immediately.
•
Foreign materials of a conductive nature, such as, but not limited to, grinding dust,
metal chips, steel wool, aluminum foil or any buildup of metallic particles should be
kept away from the charger plugs and port.
•
Always unplug the charging cable from the power supply when there is no product
attached to it.
Charging Procedure (Fig. A, B)
WARNING: For use only with the supplied charging cord.
nOTE: Fully charge device before the first use.
1. Turn the device off by sliding the 3‑position power slider
2. Insert the charging cord
3. Plug the other end of the charging cord into any compatible port (such as on a
computer). The indicator LEDs
nOTE: When first turning on the device to warm or cool mode, if the battery is at or below
10% power, the left white LED will blink for 3 seconds, then turn back to solid red or blue
depending on whether the device is set to cool or warm. When battery reaches 0% power,
3 white LEDs will flash for 5 seconds, and then the device will power off.
8
into the charging port
5
will flash white, indicating the level of charge.
1
to the center (off position).
9
.
English
7
Advertisement
Table of Contents
