Table of Contents
Advertisement
Available languages
Available languages
OPERATION
On / Off (Fig. E)
When the 3‑position power slider
off position.
1. To turn on the heat setting, slide the power slider up toward the increase strength
button
2
. Red LEDs will illuminate.
2. To turn on the cool setting, slide the power slider down toward the decrease strength
button
3
. Blue LEDs will illuminate.
3. To turn the unit off, slide the power slider to the center.
Setting Temperature Levels (Fig. A, F)
1. Turn the unit on to the heat or cool setting as described in the On / Off section.
nOTE: The unit will always default to the lowest setting when turned on.
2. To increase the temperature level, press the increase strength button
3. To decrease the temperature level, press the decrease strength button
4. The number of indicator LEDs
1 blue/red LED
2 blue/red LEDs
3 blue/red LEDs
nOTE: There is a temperature regulator, so certain functions will be disabled depending on
the initial temperature of the device when turning on.
•
If device temperature is above high safety limit when starting device, the heat setting
will be disabled. 1 red LED will blink for 10 seconds, then device will power off.
•
If device temperature is below low safety limit when starting device, the cool setting will
be disabled. 1 blue LED will blink for 10 seconds, then device will power off.
•
If the environmental temperature is approximately 107 °F (42 °C) or higher, the heat
setting will be disabled.
•
If the environmental temperature is approximately 60 °F (15 °C) or lower, the cool setting
will be disabled.
Pulsing Mode
To help regulate a consistent feeling of cooling and heating, the temperature of the cooling/
heating plate
4
fluctuates on all cooling modes and high heating mode.
1
is located in the middle of the slider, the unit is in the
5
illuminated indicates the strength of the temperature setting.
Low cool/heat
Moderate cool/heat
High cool/heat
English
2
.
3
.
9
Advertisement
Table of Contents
