Table of Contents
Advertisement
Commissioning (continued)
Installer test
Purpose:
To make a quick check that all luminaires in a group are well-commissioned and work as expected, a simple switch
on/off or dimming command can be given to the group to verify that commissioning was done as desired.
How to:
• Tap the three dots and choose "Enable Test Mode." Now the whole group of lights or individual luminaires can be
switched on and off with the app. With a simple adjustment of the blue bar, the dim level of the luminaires in the
group can be controlled. Verify that all luminaires respond properly! In test mode, the response of the fixtures is
not immediate and might need a few seconds.
• After testing, leave the test environment by going back one screen (arrow in upper left corner).
Remarks:
• The device information can be obtained by selecting the name of the device. This information can be copied to
the clipboard by a long press.
PLt-20022UM - EasySense MasterConnect User Manual 09/22 page 10 of 43
Advertisement
Table of Contents
