Table of Contents
Advertisement
Installer test
Purpose:
To make a quick check that all luminaires in a group are well-commissioned and work as expected, a simple switch on/off or dimming command can be
given to the group to verify that commissioning was done as desired.
How to:
• Tap the three dots and choose "Enable Test Mode". Now the whole group of lights or individual luminaires can be switched on and off with the app.
With a simple adjustment of the blue bar, the dim level of the luminaires in the group can be controlled. Verify that all luminaires respond properly! In test
mode the response of the fixtures is not immediate and might need a few seconds.
• After testing leave, the test environment by going back one screen (arrow in upper left corner).
Remarks:
• The device information can be obtained by selecting the name of the device. This information can be copied to the clipboard by a long press.
13
Advertisement
Table of Contents
