Please take a few moments to carefully read through this manual. Incorrect operation of the appliance can lead to danger and injury. No liability will be accepted for improper use! Possible dangers are marked with these symbols: Warning: Risk of injury if not Risk of electric shock due to observed incorrect handling or opening of...
Page 3
Visual Inspection, Polarity Test, Earth Continuity, Insulation Resistance and Functional Testing. • Buffalo recommend that this product is connected to a circuit protected by an appropriate RCD (Residual Current Device). • The appliance is NOT approved for filtration of liquids other than frying oil.
• Short instruction BUFFALO prides itself on quality and service, ensuring that at the time of unpacking the contents are supplied fully functional and free of damage. Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.
Safety functions Adjusting the filtration time To set the filtration time, follow the steps in Tilt and vibration protection chapter “Checking the factory settings”, then: • If the appliance is placed inclined more than 15°, or tilts/vibrates too much due to a defect 1.
Filtration process Stopping filtration prematurely Preparing for filtration 1. Press the Start / Stop button. The filter 1. Lift the appliance out of the drip pan. indicator shuts off. 2. Insert the filter paper into the pump-filter unit 2. Lift the appliance and let residual oil flow into (see chapter “Changing the filter paper”).
Cleaning, Care & Maintenance Notes • Switch off and disconnect from the power supply before cleaning and service. • Clean the pump-filter unit every time the filter paper is changed. • Clean The appliance only when it is cooled down. •...
Troubleshooting If you find any faults not listed here, please Call Buffalo agent or qualified technician. Fault Probable Cause Solution Power indicator (red LED) • Power cord not plugged in • Plug in the appliance remains inactive • Power cord defective •...
Technical Specifications Note: Due to our continuing program of research and development, the specifications herein may be subject to change without notice. Model CU489 Nominal voltage 220-240V~, ±10%, 50-60Hz Nominal power consumption Approx. 2.0A at 230V Maximum power 500W Noise level <85db...
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of BUFFALO. Every effort is made to ensure all details are correct at the time of going to press, however, BUFFALO reserves the right to change specifications without notice.