Care & Cleaning - Breville Commercial Smoking Gun Pro Instruction Book

Care & Cleaning
1. Before cleaning, make sure the unit is
completely cooled down and power dial
is positioned to off position. Remove the
batteries.
2. Remove the burn chamber from the barrel.
Invert the burn chamber and tap on a solid
surface to remove any remaining wood
chips or ash. The burn chamber may be
cleaned by hand with warm soapy water or
by placing in a dishwasher.
3. Twist the barrel counter-clockwise and
pull forward to remove. The barrel may be
cleaned by hand in warm soapy water or by
placing in the dishwasher.
4. Mesh filter can be cleaned with warm soapy
water and small brush as required.
5. Clean hose and tube ends in warm soapy
water as required.
6. Use damp cloth to clean the main unit.
Do not immerse in water.
7. The fan can be removed by loosening the
set screw (rotating counter-clockwise)
using the hex key provided. Once loose the
fan can be slid forward to remove from the
motor shaft. The fan may be cleaned by
hand in warm soapy water. It is not suitable
for the dishwasher. Ensure it is completely
dry before re-assembly.
8. The O–ring can be removed by hooking
under it (through the small slot above the
fan) using the hex key and levering it off
carefully.
Assembling the Fan
1. The red O–ring should be assembled
into the recess on the leading edge of the
cylindrical section protruding from the front
of the main housing. Ensure it is seated
within the groove without any twisting.
2. Assemble a small set screw into the small
hole in the side of the fan.
10
3. Slide the fan onto the motor shaft
protruding from the front of the above
cylinder until an approximate gap of 1mm
is behind it. Use the hex key to tighten the
set screw, applying a slight force (do not
over-tighten).
NOTE
• Do not use unit without the barrel, burn
chamber, fan and O-ring present.
• Do not use unit if there is no mesh filter in
the burn chamber.
• Do not use to bubble smoke through liquid
- this is not the intended use (see techniques
section on page 9).
• Hose can be stored in loop to contain smell.
• Remove the batteries if the device is not to be
used for a long period of time.
• Allow the unit to cool completely between
consecutive burns.
• Burn chamber, spring, barrel and O–ring can
be put in the dishwasher.
• If the O–ring is very sticky and makes the
barrel hard to assemble, a small amount of oil
can be placed on the outer faces to make it
lubricated. Do not operate the unit without
the barrel in place.
• Replace mesh filter if it becomes clogged.