Oven Door; Soft Close Drawer - GE Pofile PHS930BPTS Owner's Manual

Oven Door

The door is very heavy. Be careful when removing and lifting the door.
Do not lift the door by the handle.
To remove the door:
1. Fully open the door.
2. Pull the hinge locks down toward the door frame, to
the unlocked position. A tool, such as a small flat-
blade screwdriver, may be required.
3. Firmly grasp both sides of the door at the top.
4. Close door to the door removal position. The door
should be open approximately 3" with no obstruction
above the door.
5. Lift door up and out until both hinge arms are clear of
the slots.
Slot
Hinge lock
Pull hinge locks down to unlock

Soft Close Drawer

The storage drawer is a good place to store cookware
and bakeware. Do not store plastics or flammable
material in the drawer.
The storage drawer may be removed for cleaning under
the range. Clean the storage drawer with a damp cloth or
sponge. Never use harsh abrasives or scouring pads.
Your storage drawer has metal rails.
To remove the drawer:
1. Pull drawer straight out until it stops.
2. Press the left rail
release in and press
the right rail release in,
while pulling the drawer
forward and free.
49-2000990 Rev. 1
To replace the door:
1. Firmly grasp both sides of the door at the top.
2. Starting on the left side, with the door at the same
3. Fully open the door. If the door will not fully open, the
4. Push the hinge locks up against the front frame of the
5. Close the oven door.
Hinge
Removal position
To replace the drawer:
1.
2.
3.
In rare cases, the soft close mechanism may become
uncoupled from the drawer. To reset the mechanism:
1.
2.
3.
angle as the removal position, seat the indentation of
the hinge arm into the bottom edge of the hinge slot.
The notch in the hinge arm must be fully seated into
the bottom of the slot. Repeat for right side.
indentation is not seated correctly in the bottom edge
of the slot.
oven cavity, to the locked position.
Hinge
arm
lock
Push hinge locks up to lock
Place the left drawer rail around the inner left rail
guide and slide it in slightly to hook it.
Place the right
drawer rail around
the inner right rail
guide and slide it
in slightly to hook
it.
Slide the drawer
all the way in.
Remove the drawer.
Slide the catch pin forward, both sides as
applicable.
Reinstall the drawer.
Hinge arm
Bottom
edge of
slot
Indentation
Catch Pin
29