Advertisement
Add Managed Devices to the FMC
Caution
When a VDB update includes changes applicable to managed devices, the first manual or scheduled deploy
after installing a new VBD update may result in a small number of packets dropping without inspection.
Additionally, deploying some configurations restarts the Snort porcess, which interrupts traffic inspection.
Whether traffic drops during this interruption or passes without further inspection depends on how the target
device handles traffic. See the
information.
Before you begin
Make sure the FMC can access the internet.
Procedure
Step 1
Select System > Tools > Scheduling, then click Add Task.
Step 2
From the Job Type list, select Download Latest Update.
Step 3
Specify that you want to schedule a Recurring task, and establish a weekly schedule choosing appropriate
values for the Start On, Repeat Every, Run At and Repeat On fields.
Step 4
Type a Job Name, and next to Update Items, check the Vulnerability Database check box.
Step 5
Click Save.
Step 6
Select System > Tools > Scheduling, then click Add Task.
Step 7
From the Job Type list, select Install Latest Update.
Step 8
Specify that you want to schedule a Recurring task, and establish a weekly schedule choosing appropriate
values for the Start On, Repeat Every, Run At and Repeat On fields.
Step 9
Type a Job Name, and next to Update Items, check the Vulnerability Database check box.
Step 10
Click Save.
Add Managed Devices to the FMC
For each managed device, use these instructions to establish a simple deployment that does not incude
multi-tenancy, clusters, or high availability. To configure a deployment using any of these features, see the
Firepower Management Center Configuration Guide
Before you begin
• Perform the device-specific setup activities and configure the device for remote management as described
• If your environment uses NAT, make note of the NAT ID used during device setup.
Cisco Firepower Management Center 1000, 2500, and 4500 Getting Started Guide
38
Firepower Management Center Configuration Guide
in the
Getting Started Guide
I m p o r t a n t
Be sure to note the registration key you use for the device.
Cisco Firepower Management Center 1000, 2500, and 4500 Getting Started Guide
for your version.
for that device.
for your version for more
Advertisement
