Advertisement
Connect Cables Turn On Power Verify Status for Versions 6.5 and Later
Figure 5: Cable Connections
1
(Models 2500 and 4500 only.)
eth2 management interface
10-Gigabit Ethernet SFP+ support
Use only Cisco-supported SFPs.
3
USB keyboard port
eth0 management interface (labeled "1")
5
Gigabit Ethernet 10/100/1000 Mbps interface,
RJ-45
eth0 is the default management interface.
7
VGA port (DE-15 connector)
Console messages are sent to this port by default.
Before you begin
Important
Read the
• Rack-mount the appliance as described in the
4500 Hardware Installation
Procedure
Step 1
(Optional, applies only to models 2500 and 4500) eth2 management interface —If your model includes
10-Gigabit Ethernet SFP+ interfaces, install any FMC-supported SFP+ transceivers and cables as needed.
You can connect this interface to the same or different network from your other management interfaces
depending on your network needs. For more information about management interfaces and network topology,
see the
Firepower Management Center Configuration
Cisco Firepower Management Center 1000, 2500, and 4500 Getting Started Guide
10
Regulatory and Compliance Safety Information
Guide.
Cisco Firepower Management Center 1000, 2500, and 4500 Getting Started Guide
2
(Models 2500 and 4500 only.)
eth3 management interface
10-Gigabit Ethernet SFP+ support
Use only Cisco-supported SFPs.
4
Serial console port
Use the console cable (RJ45 to DB9) to connect
a computer to the appliance.
eth1 management interface (labeled "2")
6
Gigabit Ethernet 10/100/1000 Mbps interface,
RJ-45
document before installing the FMC chassis.
Cisco Firepower Management Center 1000, 2500, and
Guide.
Advertisement
