Functional Description - Makita 6407 Instruction Manual

FUNCTIONAL
DESCRIPTION
1
2
1. Switch trigger
2. Lock button
A
B
1. Reversing switch lever
ASSEMBLY
3
1
1. Chuck
2. Chuck key
3. Tighten
CAUTION:
• Always be sure that the tool is switched off and unplugged before
adjusting or checking function on the tool.
Switch action
003015
CAUTION:
• Before plugging in the tool, always check to see that the switch trigger
actuates properly and returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Tool speed is increased by
increasing pressure on the switch trigger. Release the switch trigger to stop.
For continuous operation, pull the switch trigger and then push in the lock but-
ton.
To stop the tool from the locked position, pull the switch trigger fully, then
release it.
Reversing switch action
003553
This tool has a reversing switch to change the rotational direction. Move the
1
reversing switch lever to the
tion or the
CAUTION:
• Always check the rotational direction before operation.
• Use the reversing switch only after the tool comes to a complete stop. It
will damage the tool to change the rotational direction before the tool
stops.
CAUTION:
• Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Installing or removing drill bit
For Model 6407
004641
To install the bit, place it in the chuck as far as it will go. Tighten the chuck by
hand. Place the chuck key in each of the three holes and tighten clockwise. Be
2
sure to tighten all three chuck holes evenly.
To remove the bit, turn the chuck key counterclockwise in just one hole, then
loosen the chuck by hand.
After using the chuck key, be sure to return to the original position.
position (A side) for clockwise (forward) rota-
position (B side) for counterclockwise (reverse) rotation.
5