Install/Empty Grass Catchment Basket; Mulch Kit; Lateral Grass Ejection - Grizzly BRM 42-141-OHV Translation Of The Original Instructions For Use

1. There is a drill hole located on
the lower end of the handle bar
which is tightened using the cor-
responding bolts in the holder
on the device. This creates the
lower pivot point used to adjust
the tilt angle.
2. Fasten the lower handle bar (4)
using the bar fastening screws
and nuts (4a) (To do that, use
the assembly key
You can determine the desired
tilt by selecting one of the two
possible screw positions.
3. Unfold upper handlebar (1)
and push locking lever (3)
D
toward bar.
4. Fix the Bowden cables to the
bar using the cable clamp (5)
Install/empty grass catchment
basket
Caution: Do not operate the
equipment with the grass col-
lection box or impact protection
installed incompletely. Risk of
injury!
Assemble grass catchment
basket (20):
1. Pull plastic loops (26) over bas-
ket rods. Insert the handle into
the collection box and fasten it
with the associated screw.
Fixing the Grass Collection
Box onto the Equipment:
2. Lift up shock protection (6).
3. Hook the grass collection box
(20) into the mounting provided
for this (27) on the rear of the
equipment.
32).

Mulch kit

Lateral grass ejection

4. Release the impact protection
(6). It holds the grass collection
box in position.
Dismantling/Empty out the
Grass Collection Box:
5. Lift the impact protection (6) and
remove the grass collection box
(20).
6. Empty catchment basket (see
chapter „Disposal / Environmen-
tal Protection") and re-install it.
Prior to using the mulch kit, the
lateral ejection canal has to be re-
moved (see ).
Attaching mulch kit
1. Remove the collection box
( 20), if used.
2. Lift the impact protection (6).
3. Insert the mulch kit (25). The
red locking button clicks into
place.
Remove mulch kit
4. Lift the impact protection (6).
5. Insert the red locking button
downwards and remove the
mulch kit (25).
Before using the lateral grass ejec-
tion, the mulch kit (
inserted and the grass collection
box ( 20) has to be removed.
Install lateral ejection canal
1. Unlock the lateral impact protec-
tion (16) by pulling the locking
element (16a) to the left and
GB
25) has to be
83