Operation - Makita VC006GM Instruction Manual

Installing MAKPAC
Optional accessory
CAUTION:
Do not stand on or sit on the top of
the appliance. It may fall down because of instability.
CAUTION:
Be careful with the operation when
installing MAKPAC. Failing to do so may result in
personal injury or damage to the appliance.
CAUTION:
When MAKPAC is installed on the
appliance, do not lift the appliance with the han-
dle of MAKPAC.
CAUTION:
When moving the appliance which
is installed MAKPAC, do not push MAKPAC but
the body of appliance. Pushing MAKPAC may break
the latches and drop MAKPAC, which may result in
personal injury.
Connectable and stackable MAKPAC storage cases
can be installed on top of the cleaner. The cases
are available in many sizes and styles to suit your
preferences.
1. Unfold the latches on top surface of the cleaner.
► Fig.22: 1. Latch
2.
Mount the MAKPAC cases on top of the cleaner
and fix it with latches.
► Fig.23: 1. Latch 2. MAKPAC
Maximum height and weight of installing MAKPAC are
315 mm and 20 kg respectively.
► Fig.24

OPERATION

WARNING:
Always use a P2-respirator.
CAUTION:
If foam or liquid escapes from the
tool, switch off immediately. Continuing to using
in this condition may cause an electric shock and
breakage of the cleaner.
WIRELESS ACTIVATION
FUNCTION
Optional accessory
What you can do with the wireless
activation function
The wireless activation function enables clean and
comfortable operation. By connecting a supported tool
to the cleaner, you can run the cleaner automatically
along with the switch operation of the tool.
► Fig.25
NOTICE:
Be sure to refer to the instruction man-
ual of the tool when using the cleaner with wire-
less activation function.
NOTICE:
Do not disassemble or tamper with the
wireless unit.
NOTICE:
To prevent dust coming into the slot
of the wireless unit, always close the lid securely
during operation and storage.
NOTICE:
Do not press the wireless activation
button too hard and/or press the button with an
object with a sharp edge.
NOTE: Wireless activation needs Makita tools
equipped with the wireless unit.
NOTE: Prior to the initial use of the wireless activa-
tion function with each tool, the tool registration is
required. Once the registration is finished with the
tool, the re-registration is not required unless it is
cancelled.
NOTE: Before registration, be sure that the wireless
unit is properly inserted.
NOTE: One wireless unit can register up to 10 links
with other wireless units. If more than 10 other wire-
less units are registered to one wireless unit, the one
registered earliest will be cancelled automatically.
NOTE: The position of the wireless activation button
varies depending on the tool.
NOTE: The cleaner also starts by pressing the power
button when the stand-by switch is set to "AUTO".
However the power button will not actuate when the
wireless activation function is used.
Installing the wireless unit
WARNING:
wireless unit at the first time only. Never open the
lid after installing it.
CAUTION:
Place the cleaner on a flat and
stable surface when installing the wireless unit.
NOTICE:
Clean the dust and dirt on the cleaner
before installing the wireless unit. Dust or dirt
may cause malfunction if it comes into the slot of the
wireless unit.
NOTICE:
To prevent the malfunction caused by
static, touch a static discharging material, such
as a metallic part, before picking up the wireless
unit.
NOTICE:
When installing the wireless unit,
always be sure that the wireless unit is inserted
in the correct direction and the lid is completely
closed.
18 ENGLISH
Open the lid when you install the