Parts Description; Installation - Makita DCX200 Instruction Manual

For preparation of the item being shipped, consult-
ing an expert for hazardous material is required.
Please also observe possibly more detailed
national regulations.
battery in such a manner that it cannot move
around in the packaging.
11.
12.
sive heat, explosion, or leak of electrolyte.
13.
14.
15.
16.
cartridge.
burst and malfunction of the tool or battery car-
tridge, resulting in burns or personal injury.
17.
It may result in a malfunction or
breakdown of the tool or battery cartridge.
18.
SAVE THESE INSTRUCTIONS.
CAUTION:
Use of non-genuine Makita batteries, or batteries that
have been altered, may result in the battery bursting
also void the Makita warranty for the Makita tool and
charger.
1.
less tool power.
2.
3. Charge the battery cartridge with room tem-
4.
5.
Installing the batteries to
-
-
-

PARTS DESCRIPTION

Fig.1
1 Power button
3 Plug
Optional accessory
Fig.2
1 Battery holder for CXT
battery cartridge
-
3 Battery BL1055B
5 LXT battery cartridge
(14.4 V / 18 V)

INSTALLATION

Battery cartridges used with battery holder
Refer to the instruction manual of the charger for how to
charge the battery.
Battery BL1055B
Open the cover on the USB port. Connect the battery
and AC Power Adapter ADP07 (not included) or other
general USB charger using the USB cable supplied with
-
the battery. The recommended output spec for general
USB charger is 5 V / 3 A or lower. After that, plug the AC
Power Adapter ADP07 to the mains. When the charging
Power Adapter and disconnect the USB cable, and then
close the cover.
1. AC Power Adapter ADP07 2. Battery
BL1055B 3. Cover 4. USB cable
Lighted
9 ENGLISH
2 Battery pocket
- -
2 Battery holder for LXT
battery cartridge
4 CXT battery cartridge
(10.8 V - 12 V max)
- -
capacity
100%
(The charging
50% to 100%
25% to 50%
Less than
25%